This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Sending Arduino data while using Phyphox editor
Thumbs Up 
(03-22-2023, 03:45 PM)Jens Noritzsch Wrote: Dominik likely will not see your post until end of next week, so I (try to) answer your question.

The phyphox part for BLE is documented at You need to provide an “offset” attribute so that phyphox finds the correct place of the value. If all values in a package should end up in the same buffer, then there is a “repeating” attribute in order to achieve that.

Thank you Jens!
Got it. Now it works!

Messages In This Thread
RE: Sending Arduino data while using Phyphox editor - by mprof9 - 03-22-2023, 04:27 PM

Forum Jump: