This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Use CPM as units for Magnetic/Acceleration Spectrum
#1
Hello, I would like to use CPM (counts per minutes) as a unit in the Acceleration Spectrum experiment.
The experiment has been very useful for basic vibration analysis. It is an easy way  to measure the speed of motors or other spinning equipment, but rotational speed is not measured in Hz. It would be very helpful if Phyphox was able to do the math(x60) for you by directly using CPM (Counts per Minute) or RPM (Rotations per Minute .

Here is my phone placed on the hood of my oven fan, it can measure up to 12,600 CPM this way.
   

It would also be useful in the Magnetic Spectrum, since it is also useful measuring electric motors.
Here is my phone using the magnetic sensor to measure a large water pump motor, it can only measure up to 3000RPM this way, but the noise is much better.

   
Reply


Messages In This Thread
Use CPM as units for Magnetic/Acceleration Spectrum - by canucktux - 07-16-2019, 08:30 AM

Forum Jump: