This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Sampling rate
#1
Hey!
I am currently recording data while running.
For this I have used "acceleration with g".

For the subsequent analysis I would like to map the data in a FFT and filter. But for this I need the exact sampling rate which is used in Phyphox.

Can someone tell me which sampling rate (or just frequency) is used for acceleration with g?


thank you for your help
Reply
#2
The maximum rate is requested. You could find it either in our phyphox.org/sensordb/ by looking for your device or read it off the time difference between data points.
Reply
#3
Hey,
in addition, you should see your (max) sampling rate in the "acceleration spectrum" experiment on the bottom.
Reply


Forum Jump: