This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Measurement of the resonance curve (Acoustics)
#17
Shocked 
I have slightly modified the program after version 3 obtained by Julien in order to have "infinite" measurements (now version 4). So, I measured not only an isolated resonance of the Helmholtz resonator (100 ml Erlenmeyer flask) studied at the beginning, but also a PVC tube closed at one end which gives a series 1:3:5 harmonics corresponding to the standing waves. I obtained the expected peaks (see the screen capture) but their heights were growing ruffly proportional to the frequency. I wonder if this is not an artifact of the signal treatment in the phyphox program. In the attached figure I have divided the signal by frequency (upper panel is the acoustic response of the Helmholtz resonator and lower panel is the corrected response of the tube)... Evidently the 1/f correction can be introduced to the acquisition program, but it has to be first understood (the phyphox program was developed from the given examples).
         


Attached Files
.phyphox   Resonance 4.phyphox (Size: 139.37 KB / Downloads: 1,443)
Reply


Messages In This Thread
RE: Measurement of the resonance curve (Acoustics) - by solid - 04-12-2020, 05:18 PM

Forum Jump: