This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Gas pressure thermometer versus temperature sensor (Kitchen physics with phyphox)
#5
Hi,
As promised I have done a phyphox program for two SensorTag sensors: Humidity and Pressure. Both provide temperature measurements. After the specification of the humidity sensor (HDC1000 of Texas Instruments) it can measure the temperature (T1) from -40°C to + 125°C, but in reality it starts to have problems below about -10°C (see the corresponding screen capture). The temperature (T2) given by the pressure sensor (BMP280 from Bosch Sensortec, full accuracy temperature range from 0°C to 65°C)  after my correction of the initial phyphox program has no anomalies by passing to negative temperatures. T1 and T2 are close, but temperature estimated from the pressure (pV = nRT, V=const) is changing faster.
               


Attached Files
.phyphox   Barometric and Humidity(HTPTmin).phyphox (Size: 8.2 KB / Downloads: 388)
Reply


Messages In This Thread
RE: Gas pressure thermometer versus temperature sensor (Kitchen physics with phyphox) - by solid - 04-27-2020, 09:14 AM

Forum Jump: