This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Time interval with three phones
#1
Time interval with three phones

If phone one takes a photo (with flash) of phones two and three while both measure light you should get two stopwatches starting at the same time.

See gif below (sorry for quality and that only one phone is triggered in the gif).
   
Is there a simple way of assessing how accurate such a measurement can be?

(for example, as in the gif, when measuring the speed of a passing LED-light mounted on a toy car)

Best regards.

//Erik
Reply
#2
On the technical side, the sensitivity and rate of light sensors heavily vary between smartphones. As far as I know, we have not seen rates beyond 10 Hz, more likely lower.

For a start, I would check how precisely the time between to flashs could be measured and if you observe differences when switching the two stopwatches. I wonder if the smartphone torch would work better as a signal?
Reply
#3
(09-21-2021, 10:54 AM)Jens Noritzsch Wrote: On the technical side, the sensitivity and rate of light sensors heavily vary between smartphones. As far as I know, we have not seen rates beyond 10 Hz, more likely lower.

For a start, I would check how precisely the time between to flashs could be measured and if you observe differences when switching the two stopwatches. I wonder if the smartphone torch would work better as a signal?

Thanks for feedback Jens!

Turned out about half of the class have iPhones where the light sensor seems to be disabled (or blocked so that phyphox cannot talk to it).

The mounted light source in the gif is strong enough, see attached jpg of signals from flash and passing light source. A phone torch would do fine too, but after measuring the horizontal velocity, the toy car is supposed to continue over the edge of a table (free fall). For this experiment, mounting a phone on the toy car would probably work, but maybe just once...

Best regards.

//Erik


Attached Files Thumbnail(s)
   
Reply
#4
By the way the acoustic stopwatch is faster...
Reply
#5
(09-22-2021, 08:54 AM)solid Wrote: By the way the acoustic stopwatch is faster...

Thanks solid. Yes it is. Just realised that most students have cameras that can make slow motion films. Just filming anything in slow motion with a timer in the background solves the problem, see e.g. https://onlineklocka.se/stoppur/ .
Reply
#6
Ad light sensor on iDevices: https://phyphox.org/faq/#faqIosLight

I have not put it clearly: I thought of replacing the synchronising flash with the torch, however, judging by your graph, flash appears to work quite fine. Smile
Reply
#7
(09-22-2021, 12:21 PM)Jens Noritzsch Wrote: Ad light sensor on iDevices: https://phyphox.org/faq/#faqIosLight

I have not put it clearly: I thought of replacing the synchronising flash with the torch, however, judging by your graph, flash appears to work quite fine. Smile

My question was also quite unclear but indeed, both camera flash and a passing maglite type torch work fine as triggers.

Just that I have to find another experiment for this type of measurement when it turns out most student have a high speed camera in their pocket...

Best regards.

//Erik
Reply
#8
… and there is https://physlets.org/tracker/ Smile
Reply


Forum Jump: