This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Boiling point of liquefied gases with Arduino and PhyPhox
#3
Thank you solid for your comments.
Good your idea of using a velo pump to measure the boiling point at different pressures.
I was thinking of doing it by going to the beach and then going up to the top of a volcano at 3300 m altitude (making several intermediate measurements), a trip that in my country can be done in less than 5 hours but the Covid-19 complicates it.
If I saw the toxicity of difluoroethane on Wikipedia and was surprised because this product is over the counter and its very common use (duster).
Reply


Messages In This Thread
RE: Boiling point of liquefied gases with Arduino and PhyPhox - by Aewolframio - 05-07-2021, 09:18 PM

Forum Jump: