01-05-2023, 05:44 PM
Hi,
I am new to Phyphox and to bluetooth protocols in general. I would like to build an experiment in which I can send sensors data from Arduino to Phyphox and set up the experiment via the Editor, which has lots of useful features.
In the input tab I should choose a bluetooth input type and then specify some outputs: my issue is with the characteristic UUID of each output. Where do I get these UUIDs? Should I define them in the Arduino code and in case how (examples)? Is there detailed documentation on this stuff?
I only managed to find the 128-bit service UUID when connecting Arduino to Phyphox directly via bluetooth and scanning with the nRF Connect smartphone app, but not further than that.
Any help greatly appreciated.
Many thanks.
Mauro
I am new to Phyphox and to bluetooth protocols in general. I would like to build an experiment in which I can send sensors data from Arduino to Phyphox and set up the experiment via the Editor, which has lots of useful features.
In the input tab I should choose a bluetooth input type and then specify some outputs: my issue is with the characteristic UUID of each output. Where do I get these UUIDs? Should I define them in the Arduino code and in case how (examples)? Is there detailed documentation on this stuff?
I only managed to find the 128-bit service UUID when connecting Arduino to Phyphox directly via bluetooth and scanning with the nRF Connect smartphone app, but not further than that.
Any help greatly appreciated.
Many thanks.
Mauro