06-25-2024, 07:59 AM
Thanks a lot for all the suggestions. I believe that the split module should be able to reduce some containers in my experiment, because the split could, of course, as well happens at the start of a buffer. In the exported data file I would expect for the split buffers some NaN entries at the most recent positions when compared to the one un-split buffer which I still need for the building up the data (details skipped). I tried to enter the split module in the XML file but failed somehow, I would wait for some example given in the documentation you linked.
The visual editor has some input validation? When adding a not yet supported module manually to the XML file the visual editor won't accept that XML anymore, because it could not save later on that unsupported module? Ah, the visual editor accepts reading yet unsupported attributes, but does not write them back. Then I will continue with the visual editor to finish the experiment and only later on would try the manual optimization in the XML file.
The requireFill attribute should save some if modules in my experiment. This attribute I can use multiple times, I would expect. But the other two, requireFillThreshold and requireFillDynamic, I can only define one time, because they do not related to a specific buffer? No, also requireFill I can define only one time, isn't? It is an attribute to the analysis module and not to the data container (buffer).
Next thing I want to try is to relate in a meaningful way the accelerations from the linear acceleration sensor with the calculated lateral accelaration in a curve to verify the g's against each other. Don't see yet any strong correlation between the numbers.
Cheers
The visual editor has some input validation? When adding a not yet supported module manually to the XML file the visual editor won't accept that XML anymore, because it could not save later on that unsupported module? Ah, the visual editor accepts reading yet unsupported attributes, but does not write them back. Then I will continue with the visual editor to finish the experiment and only later on would try the manual optimization in the XML file.
The requireFill attribute should save some if modules in my experiment. This attribute I can use multiple times, I would expect. But the other two, requireFillThreshold and requireFillDynamic, I can only define one time, because they do not related to a specific buffer? No, also requireFill I can define only one time, isn't? It is an attribute to the analysis module and not to the data container (buffer).
Next thing I want to try is to relate in a meaningful way the accelerations from the linear acceleration sensor with the calculated lateral accelaration in a curve to verify the g's against each other. Don't see yet any strong correlation between the numbers.
Cheers