03-17-2025, 10:25 AM
(This post was last modified: 03-17-2025, 01:33 PM by noitarud.
Edit Reason: Rmd hint
)
Are the sensors in my device not functional because of lacking support or they are not actually what they are detected to be? The 33171016 / BU52053NVX hall effect sensor is disused.
b. Do all the sensors have an experiment associated with them? Someone is sure to find an application if they were accessible. Step, guestures, pedometer, motion accel, tilt, RMD, AMD(relative/absolute motion detector)… the custom experiment option does not even list these (maybe the generic/preexisting techniques to activate+read will be sufficient? Even for the hall?).
c. there are 44 temperature sensors inside the device ("Temp. Monitor" app), not that practical (thermal cycles could reduce device lifespan), but, if usb devices add then we could have temp too. We just need to be alerted if any get attached (my usb sticks dont add).
b. Do all the sensors have an experiment associated with them? Someone is sure to find an application if they were accessible. Step, guestures, pedometer, motion accel, tilt, RMD, AMD(relative/absolute motion detector)… the custom experiment option does not even list these (maybe the generic/preexisting techniques to activate+read will be sufficient? Even for the hall?).
c. there are 44 temperature sensors inside the device ("Temp. Monitor" app), not that practical (thermal cycles could reduce device lifespan), but, if usb devices add then we could have temp too. We just need to be alerted if any get attached (my usb sticks dont add).