To transmit more than five sets of data, what should I do?

[Jens Noriʇzsɔɥ]

Five floats, i.e. 20 bytes, is a (current?*) limitation of the Arduino BLE stack and it does not exist for ESP32 based microcontrollers. So, depending on the architecture, there are different approaches that, however, require a “handwritten” .phyphox file (check the CO2 demo, for instance, how to include it in your sketch):

• use a float array in phyphox::write (esp32 only),
  
• use a byte array in phyphox::write and convert your data appropriately. Two byte integers (and a scaling factor in the .phyphox file) might provide sufficient accuracy for your purpose. You could also use different sizes for different data,
  
• if rate is not that much of an issue, you could use one of the channels as a data index, so you could have eight floats in two data packages – leading to half the rate.
  

* Arduino is switching from mbed to zephyr. We have not looked into the first beta yet, though.