10-27-2022, 02:40 PM
Dominik is currently busy with a … sort-of other hardware project, so I try to get the answer right:
First, please be careful with ordering the boxes in the analysis tab: they are processed from left to right (and in addition the editor complains that it does not entirely support Dominik's file, see the if element documentation)…
Judging from the if element the “1”s in the button elements can by anything but “0”. The “1” in the middle append element is part of the communication with the microcontroller and its meaning is defined there, so it has –just reading the .phyphox file– nothing to do with the previous “1”s.
Note that in your image this append element would be processed after the if block and, accordingly, it would not stop bluetooth communication. Same holds for the left append element: you should place it right of the if element (so that it is put below it in the .phyphox file) or the reset would not work…
First, please be careful with ordering the boxes in the analysis tab: they are processed from left to right (and in addition the editor complains that it does not entirely support Dominik's file, see the if element documentation)…
Judging from the if element the “1”s in the button elements can by anything but “0”. The “1” in the middle append element is part of the communication with the microcontroller and its meaning is defined there, so it has –just reading the .phyphox file– nothing to do with the previous “1”s.
Note that in your image this append element would be processed after the if block and, accordingly, it would not stop bluetooth communication. Same holds for the left append element: you should place it right of the if element (so that it is put below it in the .phyphox file) or the reset would not work…