This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Sending Arduino data while using Phyphox editor
I am new to Phyphox and to bluetooth protocols in general. I would like to build an experiment in which I can send sensors data from Arduino to Phyphox and set up the experiment via the Editor, which has lots of useful features.

In the input tab I should choose a bluetooth input type and then specify some outputs: my issue is with the characteristic UUID of each output. Where do I get these UUIDs? Should I define them in the Arduino code and in case how (examples)? Is there detailed documentation on this stuff?

I only managed to find the 128-bit service UUID when connecting Arduino to Phyphox directly via bluetooth and scanning with the nRF Connect smartphone app, but not further than that.

Any help greatly appreciated.
Many thanks.

Messages In This Thread
Sending Arduino data while using Phyphox editor - by mprof9 - 01-05-2023, 05:44 PM

Forum Jump: