This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Time format and absolute time when exporting data
#13
(08-31-2020, 02:08 PM)Jens Noritzsch Wrote: Could you please specify your OS and phyphox version. I cannot reproduce it on current phyphox/iOS*: Location data for the full time, constant 1Hz rate after about 7 seconds. Velocity data (understandably) sets in then, too.

* + new simple experiment with accelerometer and location

It's an Android 8.0.0 device (Sony Xperia X Compact), phyphox is version 1.1.6, build 1010603, file format 1.10.

Same experiment like you have. Below are two screenshots from a quick experiment I took right now: While the accelerometer measured roughly 15 seconds, the GPS sensor recorded only 2 seconds of data, but the later dataset should actually start at somewhat >10.00s instead of at 0.00s


Attached Files Thumbnail(s)
       
Reply


Messages In This Thread
RE: Time format and absolute time when exporting data - by turboscholz - 08-31-2020, 02:33 PM

Forum Jump: