This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

How to add Inclination tool using plus sign for designing an experiment.
(06-18-2023, 05:49 PM)Jens Noritzsch Wrote: I would suggest to load the “Inclination” experiment into the editor (at the bottom of the window). Then add the sensors you need in the “Input” tab. Add the tabs and graphs in the “Views” tab and finally connect the sensors to the graphs so that the data is displayed.


Thank you for your suggestion, I'm now able to add the accelerometer(sensor) along with the inclination experiment and after connecting the sensor with graphs, graphs are being displayed but on exporting the data, I'm not getting the values of acc_x , acc_y and acc_z for all time stamps instead getting the values of same for only the last time stamp, so how to show all the values on exporting the file?

Messages In This Thread
RE: How to add Inclination tool using plus sign for designing an experiment. - by - 06-20-2023, 11:02 AM

Forum Jump: