07-21-2022, 01:04 PM
Hello,
I would like to use a TI SensorTag for the centripetal force experiment. I noticed that the existing experiments for the SensorTag use either the accelerometer or the gyroscope, but not both at the same time.
The bluetooth config definition varies, I assume that way the SensorTag gets configured to readout specific sensors. Is this documented anywhere? Where did the hex values in the XML came from? Is there any documentation from TI or source code of the firmware that allows you to understand how these values work?
Best regards
Stefan
I would like to use a TI SensorTag for the centripetal force experiment. I noticed that the existing experiments for the SensorTag use either the accelerometer or the gyroscope, but not both at the same time.
The bluetooth config definition varies, I assume that way the SensorTag gets configured to readout specific sensors. Is this documented anywhere? Where did the hex values in the XML came from? Is there any documentation from TI or source code of the firmware that allows you to understand how these values work?
Best regards
Stefan