This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

SensorTag interface description

I would like to use a TI SensorTag for the centripetal force experiment. I noticed that the existing experiments for the SensorTag use either the accelerometer or the gyroscope, but not both at the same time.
The bluetooth config definition varies, I assume that way the SensorTag gets configured to readout specific sensors. Is this documented anywhere? Where did the hex values in the XML came from? Is there any documentation from TI or source code of the firmware that allows you to understand how these values work?

Best regards

Messages In This Thread
SensorTag interface description - by stefan_o - 07-21-2022, 01:04 PM
RE: SensorTag interface description - by SJS - 10-03-2022, 04:56 PM

Forum Jump: