This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Recording readings from IR Sensor
#1
Hello guys,

my first post here so far.

I am using a Samung S9, equipped with the HRM-Sensor (pulse measuring, o2-saturation).

By accessing the the service mode i figured out that there might be some hidden potential if the signal from IR-sensor (and red) could be recorded.
Might be usefull for checking for
- surface roughness
- building a dew point meter (even there might be other ways for real electronics)
- determining of thickness of some materials (depending on IR-wavelength obsorbtion charackteristics).
- determining of thickness of some materials depending of theire reflectivitity.

As i couldn't figure out so far the infrared range, probaly something arround 900nm, there might be some possibilities for binary mixtures.

Have a nice weekend

TheDruide
Reply


Messages In This Thread
Recording readings from IR Sensor - by TheDruide - 02-22-2020, 04:59 PM

Forum Jump: