This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Boiling point of liquefied gases with Arduino and PhyPhox
#1
Hi, 

I recently met the PhyPhox app and found it great. 

I am a chemist and have used Arduino microprocessors to make physical and chemical measurements and when I saw the capabilities of the PhyPhox I wanted to make an example. 

The Experiment I designed uses an Arduino to measure the boiling point of liquefied gases with a DS18B20 temperature sensor transmitting data via bluetooth to my cell phone for analysis using PhyPhox.

I leave here the link of the report I made on the Instructable website for your knowledge. 

Measuring the Boiling Point of Liquefied Gases Using Arduino and PhyPhox : 4 Steps (with Pictures) - Instructables

Best regards


Attached Files
.pdf   Measuring-the-Boiling-Point-of-Liquefied-Gases-Usi.pdf (Size: 1.3 MB / Downloads: 744)
Reply


Messages In This Thread
Boiling point of liquefied gases with Arduino and PhyPhox - by Aewolframio - 05-06-2021, 11:08 PM

Forum Jump: